- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I was wondering if anybody knows how long it takes to power up a Cyclone 10 LP? I can't seem to find it anywhere in the datasheets.
Thank you very much,
Erica
Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Erica
Can you refer to section "Device Power-Up" from the below doc to check if it helps to understand the power-up timing requirement
https://www.intel.cn/content/dam/www/programmable/us/en/pdfs/literature/an/an800.pdf
Thanks.
Eng Wei
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Eng Wei,
I found it in one of the documents. It's 50us to 50ms.
Thank you very much,
Erica
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page