GPIO-HSTC Card - voltage level

FPGA, SoC, And CPLD Boards And Kits

FPGA Evaluation and Development Kits

GPIO-HSTC Card - voltage level

944 Views

Hi,

Short question: If I configure the voltage of the input pins on the HSTC side of the card to a specific Voltage level, say 1.5 V, will the voltage of the output pins on the GPIO side also be 1.5 V?

Specifically I want to connect this card:

http://www.terasic.com.tw/cgi-bin/page/archive.pl?language=english&categoryno=67&no=322

to the HSTC Connector of a SoCKit Board. Then I set the voltage level of the HSTC connector of the SoCKit Board to 1.5 V (via jumper JP2). Will I get 1.5 V output signals at the GPIO pins?

Regards

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.