FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
5239 Discussions

GPIO-HSTC Card - voltage level

Altera_Forum
Honored Contributor II
814 Views

Hi, 

 

Short question: If I configure the voltage of the input pins on the HSTC side of the card to a specific Voltage level, say 1.5 V, will the voltage of the output pins on the GPIO side also be 1.5 V? 

 

Specifically I want to connect this card: 

 

http://www.terasic.com.tw/cgi-bin/page/archive.pl?language=english&categoryno=67&no=322 

 

to the HSTC Connector of a SoCKit Board. Then I set the voltage level of the HSTC connector of the SoCKit Board to 1.5 V (via jumper JP2). Will I get 1.5 V output signals at the GPIO pins? 

 

Regards
0 Kudos
0 Replies
Reply