FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
6478 Discussions

How to operation the Configuration Flash during user mode on Cyclone V device?

AMa
Partner
‎03-11-2020 08:35 AM
733 Views

Hi,

 

If need operation Configuration Flash during user mode, how to set it? On Device and Pin option page, just have DATA 5- DATA32 can set to regular I/O, the DATA0-4 how to operation it?

I had trid to constraint DATA0-DATA4 in Pin Planner page, but it will have some error.

0 Kudos

Link Copied

1 Reply
YuanLi_S_Intel
Employee
‎03-12-2020 06:35 AM
653 Views

Hi Xiao Min,

 

You will need to use Serial Flash Mailbox IP to interact with flash during user mode.

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-gen-sfi.pdf

 

Thank You.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.