- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
I am new to FPGAs and am developing a project that implements a chroma key effect.
My inputs are a camera (Terasic D5M) and some control switches, and the output is displayed to the VGA monitor.
For the camera and VGA controller, I am using the codes provided be Terasic. The resolution in the code is 640 by 480 pixels. I would like to decrease the resolution to a lower value such as 256 by 256 pixels (I want to display to the VGA 256x256 pixels) . How can I do that?
I have attached the codes here
All help is appreciated
Thanks
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I can see that you are seeking for advice on Terasic ref design modification.
You can check with Terasic on consultation with their board or ref design related enquiry via Terasic technical support email : support@terasic.com
Thanks.
Regards,
dlim
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page