FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.

SPI - slave

AutoSpiderZ
Beginner
252 Views

I am new to programming FPGA's in VHDL.  One of my starter projects is to write VHDL that will receive a SPI message from my Raspberry Pi, that will then produce a PWM with the duty cycle set from the SPI message.  For instance, the PI may send a 25, and the FPGA will create a PWM with 25% duty cycle.  I am using this code to create the SPI slave portion of code

https://www.digikey.com/eewiki/pages/viewpage.action?pageId=7569477

My debug methods include LED's, lighting up the byte value when received.  I also have an oscilloscope to try and verify the PI is sending the message, and that the clock is being correctly read by the FPGA.  I am including a picture of my setup.

Is there a better way to watch the ports and the signals, because this method does not seem optimal and I think it is due to my not knowing what to do.  It's not working, the rx_data vector does not give very stable results.  One thing I found that I think is helping is connecting the Raspberry Pi ground to the FPGA ground. 

Any advice is greatly appreciated, I feel I am kind of floundering.  My goal is to eventually create a DMA as is used in the labview environment, which is where I first used an FPGA.  I was able to create a PWM as was found here

https://www.digikey.com/eewiki/pages/viewpage.action?pageId=20939345

 

0 Kudos
2 Replies
AutoSpiderZ
Beginner
237 Views

I am working to develop a larger project, making BMS and other useful electronic controls with low cost parts.  My goal is to control a buck-boost board like may be used in regenerative braking or other green energy projects.  Of course, this is just 1 piece of a larger puzzle, you can see here

https://codeandbuildit.com/2021/02/11/fpga-buck-boost-02-07-2021-spi-with-fpga/

I have a lot of work to do, hoping to get through this learning curve ASAP, which is kind of hard without the funding, technical ability, etc... but, each step 1 at a time

AutoSpiderZ
Beginner
185 Views

Just a quick update.  I have figured out to use the Signal Tap II Digital Analyzer provided on Quartus II.  I now receive SPI messages, and produce a PWM output based on received message.  I would like to learn more about boundary scans, creating DMA like labview does with their single board RTOS

https://zone.ni.com/reference/en-XX/help/371599P-01/lvfpgaconcepts/fpga_dma_how_it_works/

and to start will look into a ADC to gather data now.  I am very interested in the NIOS II, and the long road ahead as I continue learning better techniques including multimedia and RF comm..

https://codeandbuildit.com/2021/02/26/fpga-buck-boost-02-11-2021-qml-controlling-fpga/

I thank you for providing a great learning material (Cyclone II - <$30) at a price I can afford

Reply