FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6192 Discussions

UART ON DE1 Board from XBee wireless device

Altera_Forum
Honored Contributor II
1,164 Views

I am trying to write a Uart driver in VHDL on the DE1 board using the cyclone II chip. The data is coming from the XBee wireless device. I am putting the Data out signal from the wireless device to the GPIO pins on the DE1 board.  

 

9600 baud rate 

1 start bit 

8 data bits 

no parity 

1 stop bit 

 

it is just one wire going from the xbee to gpio. 

 

I understand what i am trying to do, but putting it into code has been difficult. Does someone know a good way to code the process for this?
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
284 Views

Hi Jim3941, 

 

Now, i also try to do this kind of project. 

i want to use xbee with QUARTUS Verilog and nios ii. 

So, if you have already finished it, would you like to teach me? 

Thank you.
0 Kudos
Reply