FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6125 Discussions

Using Cypress SPI Flash to configure Arria II GX device

HSteg
Novice
‎06-11-2020 04:22 PM
664 Views

I'm interested in using a Cypress SPI Flash memory to configure an Arria II GX FPGA. I've read that some earlier versions of Quartus check the device ID before programming. The Device ID check fails for Cypress SPI Flash Memory. Is that still the case with Quartus Prime v19 and v20?

0 Kudos

Link Copied

2 Replies
YuanLi_S_Intel
Employee
‎06-12-2020 05:08 AM
646 Views

Hi Hai,

 

Apologize that it is not with v19 and v20. You may check our 3rd party flash support at link below:

https://www.intel.com/content/www/us/en/products/programmable/configuration-device.html

 

Thank You.

 

Regards,

Bruce

0 Kudos
Copy link
HSteg
Novice
‎06-12-2020 03:11 PM
646 Views
In response to YuanLi_S_Intel

Thanks Bruce.

 

Hal

In response to YuanLi_S_Intel
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.