FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
Success! Subscription added.
Success! Subscription removed.
Sorry, you must verify to complete this action. Please click the verification link in your email. You may re-send via your
profile.
I would like to use the 5CEBA4F17C8N FPGA with two Ethernet ports connected to it (and some LED an switches). Now my question, is there any recommendation which pins/IO banks i should use?
Hi @Inematov , Just trying to help here. I am not sure I understand the problem statement. But if i take the question literally, shouldnt the Ethernet port connect to the Transceiver pins and the LEDs to GPIO pins?
Hi, the question was more about with FPGA Pin i should use to connect the data lines from the PHY. Meanwhile after some hours of reading documents and application notes, its clear ;-)
