- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I want to reference the PCB of DE2. The document is NiosII_CycloneII_R01.pcb,which can be finded in the directory of nios. But I can't open it by protel99se and DXP2004sp2. :confused: Which edition can open it?
ThanksLink Copied
5 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Contact the makers of the DE2 board for the answer to t hat question.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
... and plz post the solution here, too :)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
according to some project documents, the evaluation board design was made with PADS PowerPCB, a product aquired by Mentor. Unfortunately it isn't among the design systems I have access to, so I can't check. Regards, Frank- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I was told by MySupport it was Cadence
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I refer to the design file "10397Altera_NiosII_CycloneII_R02.pcb". In an additional document it's declared as PADS 5.0. If you're talking of different design: The file extension *.PCB to my knowledge isn't used by the common Cadence tools. Allegro has *.BRD, Orcad PCB has *.DSN. Regards, Frank
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page