- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
I am trying to convert a CNN model from ONNX to OpenVINO.
The following 2 ops are missing:
Instructions/layers that do not have attribute extractors: [ WARNING ] Sub (2) [ WARNING ] Sub_78 [ WARNING ] Sub_140 [ WARNING ] Min (3) [ WARNING ] Min_87 [ WARNING ] Min_88 [ WARNING ] Min_89
Min and Sub. Can you please provide some guidance as to how/where to add them?
Thank you
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ra Tr,
Sub should be a supported ONNX layer while Min is not.
You can check ONNX supported layers to see a list of supported layers.
There is a section for implement custom layer using the Custom Layers Guide.
However, it seems that ONNX conversion could not support custom layers.
Therefore, I would recommend you to tweak your model to not use the Min layer if possible.
Additionally, here is a list of validated models and topologies that are compatible.
Regards,
Rizal
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is this a naming problem?
I see Minimum is supported here: https://docs.openvinotoolkit.org/latest/openvino_docs_ops_arithmetic_Minimum_1.html
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ra,
Intel will no longer monitor this thread since we have provided a solution. If you need any additional information from Intel, please submit a new question.
Regards,
Rizal
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page