Intel® Enpirion® Power Solutions
Interact with Intel® product support specialists on Intel® Enpirion® DC-DC Step-Down Power Converters
Announcements
This forum offers only peer-to-peer support. Thank you!
224 Discussions

Cyclone 10LP device migration fom a 10MDAF256C to a larger device with 4 PLL's. Can the no connect pins D4 and N13 (vccd_pll3 and vccd_pll4) be connected to 1.2 volts on a 10MDAF256C device?

HMuld1
Beginner
‎07-31-2019 02:43 PM
806 Views
Solved Jump to solution
 
0 Kudos
1 Solution
AnandRaj_S_Intel
Employee
‎08-01-2019 12:37 AM
457 Views
Solved Jump to solution

Hi Henry,

 

When designing for device migration you may connect NC pins to power, ground, or a signal trace depending on the pin assignment of the devices selected for migration. However, if device migration is not a concern, leave these pins floating.

 

Regards

Anand

View solution in original post

0 Kudos
Copy link

Link Copied

1 Reply
AnandRaj_S_Intel
Employee
‎08-01-2019 12:37 AM
458 Views
Solved Jump to solution

Hi Henry,

 

When designing for device migration you may connect NC pins to power, ground, or a signal trace depending on the pin assignment of the devices selected for migration. However, if device migration is not a concern, leave these pins floating.

 

Regards

Anand

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.