Cyclone 10LP device migration fom a 10MDAF256C to a larger device with 4 PLL's. Can the no connect pins D4 and N13 (vccd_pll3 and vccd_pll4) be connected to 1.2 volts on a 10MDAF256C device?

[AnandRaj_S_Intel · Accepted solution]

Hi Henry,

When designing for device migration you may connect NC pins to power, ground, or a signal trace depending on the pin assignment of the devices selected for migration. However, if device migration is not a concern, leave these pins floating.

Regards

Anand