Intel® Enpirion® Power Solutions
Interact with Intel® product support specialists on Intel® Enpirion® DC-DC Step-Down Power Converters
Announcements
This forum offers only peer-to-peer support. Thank you!
223 Discussions

Cyclone 10LP device migration fom a 10MDAF256C to a larger device with 4 PLL's. Can the no connect pins D4 and N13 (vccd_pll3 and vccd_pll4) be connected to 1.2 volts on a 10MDAF256C device?

HMuld1
Beginner
705 Views
 
0 Kudos
1 Solution
AnandRaj_S_Intel
Employee
356 Views

Hi Henry,

 

When designing for device migration you may connect NC pins to power, ground, or a signal trace depending on the pin assignment of the devices selected for migration. However, if device migration is not a concern, leave these pins floating.

 

Regards

Anand

View solution in original post

0 Kudos
1 Reply
AnandRaj_S_Intel
Employee
357 Views

Hi Henry,

 

When designing for device migration you may connect NC pins to power, ground, or a signal trace depending on the pin assignment of the devices selected for migration. However, if device migration is not a concern, leave these pins floating.

 

Regards

Anand

0 Kudos
Reply