Modelsim issue

[Ed3732]

When I invoke 

ModelSim - INTEL FPGA STARTER EDITION 2020.1

Revision: 2020.02
Date: Feb 28 2020

I receive this prompt:

couldn't open "transcript": permission denied
# Reading pref.tcl

How do I fix this problem.

Thank you 

[RichardTanSY_Altera]

If you seeing this (as attached), you can safely ignore the error.

I'm not sure why it's there in the first place, but it won't have any impact on your simulation or anything else.

As they say, if it doesn't cause any problems, it might not actually be an issue.

Best Regards,

Richard Tan

p/s: If you find any answers from the community or Intel Support to be helpful, we encourage you to mark them as the best answer or rate them 4/5 in the survey. 

[Ed3732]

Yes you are right. I ignored that message permission denied. The simulator does work.

Thanks.

[RichardTanSY_Altera]

I'm glad to hear that your question has been addressed. Now, I will transition this thread to community support. If you have any further questions or concerns, please don't hesitate to reach out. Thank you and have a great day!

Best Regards,

Richard Tan