Intel® FPGA Software Installation & Licensing
Installation and Licensing that’s includes Intel Quartus® Prime software, ModelSim* - Intel FPGA Edition software, Nios® II Embedded Design Suite on Windows or Linux operating systems.

Modelsim issue

Ed3732
Novice
776 Views

When I invoke 

ModelSim - INTEL FPGA STARTER EDITION 2020.1

Revision: 2020.02
Date: Feb 28 2020

I receive this prompt:

 

couldn't open "transcript": permission denied
# Reading pref.tcl

 

How do I fix this problem.

Thank you 

0 Kudos
3 Replies
RichardTanSY_Intel
755 Views

If you seeing this (as attached), you can safely ignore the error.

I'm not sure why it's there in the first place, but it won't have any impact on your simulation or anything else.

capture.JPG

As they say, if it doesn't cause any problems, it might not actually be an issue.

 

Best Regards,

Richard Tan

 

p/s: If you find any answers from the community or Intel Support to be helpful, we encourage you to mark them as the best answer or rate them 4/5 in the survey. 

 

0 Kudos
Ed3732
Novice
735 Views

Yes you are right. I ignored that message permission denied. The simulator does work.

Thanks.

0 Kudos
RichardTanSY_Intel
726 Views

I'm glad to hear that your question has been addressed. Now, I will transition this thread to community support. If you have any further questions or concerns, please don't hesitate to reach out. Thank you and have a great day!


Best Regards,

Richard Tan


0 Kudos
Reply