Installation of Quartus Prime Lite Edition

[sne]

After downloading Quartus Prime Lite Edition (20.1) I cannot create a new project (error message: a device installation file is missing). The appropriate file can be found on the website (e.g. cyclone-20.1.1.720). Could you tell me, where to store this file? Thanks.

[RichardTanSY_Intel]

Refer to Section 3.9. Adding Device Support and Other Intel FPGA Software to Existing Installation

In the User Guide below:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/manual/quartus_install.pdf

Best Regards,
Richard Tan

p/s: If any answer from the community or Intel support are helpful, please feel free to give Kudos. 

[RichardTanSY_Intel]

I have yet to receive any response from you to the previous question/reply/answer that I have provided but I believed that I have answered your question. 
With that, I will now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.

Best Regards,
Richard Tan

p/s: If any answer from the community or Intel support are helpful, please feel free to give Kudos.