- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I build a HLS project and verify the correctness via simulation in HLS project. I use one mm_host interface in my component interface.I find the address change correctly in HLS project.
my component is here with hls_always_run_component enabled
I build a quartus project and add this IP into the project,run IP Geneartion command and generate simulator setup script for IP command, I source and genrated tcl script, there are no errors in above steps.
I find the high part of my mm_host address are in x state while read enable is valid.
I don't know where are the problems. Can anyone help me,Thanks.
My component is in attached.
Any example project with right addresses in HLS and quartus simulation is also apprecated.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi chalie_Robert,
I am closing the thread for now as we do not receive any response from you to the previous question/reply/answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.
Thanks.
Regards,
Aik Eu
![](/skins/images/7FC17B7B85029576C25F1E43CE255B51/responsive_peak/images/icon_anonymous_message.png)
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page