high part of mm_host address are x state in quartus simulation.

[chalie_Robert]

I build a HLS project and verify the correctness via simulation in HLS project. I use one mm_host interface in my component interface.I find the address change correctly in HLS project.

my component is here with hls_always_run_component enabled

 I build a quartus project and add this IP into the project,run IP Geneartion command and generate simulator setup script for IP command, I source and genrated tcl script, there are no errors  in above steps.

I find the high part of my mm_host address are in x state while read enable is valid. 

I don't know where are the problems. Can anyone help me,Thanks.

My component is in attached. 

Any example project with right addresses in HLS and quartus simulation is also apprecated.

[aikeu]

Hi chalie_Robert,

Probably the link below may help:

https://www.intel.com/content/www/us/en/docs/programmable/683053/19-1/running-a-high-level-synthesis-hls-design-40650.html

Thanks.

Regards,

Aik Eu

[aikeu]

Hi chalie_Robert,

I will close the thread if no further question.

Thanks.

Regards,

Aik Eu

[aikeu]

Hi chalie_Robert,

I am closing the thread for now as we do not receive any response from you to the previous question/reply/answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.

Thanks.

Regards,

Aik Eu