Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16556 Discussions

DE-series board pin assignment for Cyclone 10

LChow3
Novice
540 Views

I don't have the hardware DE-series board. But I like to learn about how to configure it using Quartus Prime. I have downloaded Cyclone 10 since it's free. Or which device family shall I use?

 

Where can get the DE-series board pin assignment for Cyclone 10?

 

In the Assignment Editor, I need to key in the Value for each pins. How shall I do that?

 

 

Thank you.

0 Kudos
3 Replies
Deshi_Intel
Moderator
515 Views

HI,

 

I presume you are new Quartus user. Pls see my reply below.

 

  1. which device family shall I use ?
  • This will depends on which board that you plans to use and which intel FPGA is soldered on the board.
    • After that, you can then create Quartus project specifying exact FPGA part number that matched with FPGA used on the dev kit board.
  1. Where can get the DE-series board pin assignment for Cyclone 10 ?
  • Again, it depends on which dev kit board that you plans to use first.
    • After that, you can google for that dev kit website. The website will contains either user guide manual doc or board schematic file that show you the pin assignment
  1. In the Assignment Editor, I need to key in the Value for each pins. How shall I do that ?

 

Thanks.

 

Regards,

dlim

0 Kudos
LChow3
Novice
515 Views
0 Kudos
Deshi_Intel
Moderator
515 Views

welcome !

 

Alright, I will be setting this case to closure.

 

Feel free to file new forum thread if you still have enquiry in future.

 

Thanks.

 

Regards,

dlim

0 Kudos
Reply