- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How can I show all signals grouped into buses in the RTL viewer, and not expand each bus into individual signals at block interfaces?
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Do you mean to group from the first screenshot to the second screenshot? You may click on the '-' sign on the top left of the block.
Thanks.
Best regards,
KhaiY
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am talking situations where the block is collapsed like your second screenshot, but the bus interface is expanded to show every signal. For example, all signals in the q_a bus are expanded and shown, which is unnecessary. Please see the attached image. All signals are on the same bus, but I want the bus to show up as a single bus line, instead of showing all signals, such as [14] through [22] in the attached screenshot.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The signals on a bus are normally grouped together in the RTL viewer. May I see the destination of these signals?
Thanks.
Best regards,
KhaiY
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Do you have any updates?
Thanks.
Best regards,
KhaiY
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page