Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
17267 Discussions

NIOSV firmware stuck when juart-terminal is not open for the print messasges.

prashant_gohel
Novice
‎09-24-2025 03:55 AM
140 Views

Hi,

I am facing an issue where the NIOSV firmware gets stuck if the JUART terminal is not open for printing messages. Once I open the JUART terminal, everything works fine.

Is there any way or BSP setting I can use to prevent the NIOSV firmware from getting stuck when the JUART terminal is not open?

0 Kudos

Link Copied

1 Reply
BoonBengT_Altera
Moderator
‎09-29-2025 07:05 PM
28 Views

Hi @prashant_gohel,


Thank you for posting in Intel community forum and hope all is well.

Notice as there is a duplicate in discussion in the mention links below:

- https://community.intel.com/t5/forums/forumtopicpage/board-id/nios-II-embedded-design-suite/message-id/54145#M54145


Hence will follow through the discussion above and close this as duplicate.

please do let us know if there is any concern.


Best Wishes

BB


0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.