- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone!
I'm trying to use tri-state controller to connect nios2 system to w5300 chip (w5300 is considered as SRAM). Write command works very strange: two nWR pulses and two nCS are formed, so two write operations are executed. Address value stays the same during both write operations, but data changes to all zeros before second operation, so firstly correct value is written into SRAM, but then controller writes zero to the same address. If I change some timing options (setup time=0, write wait time=0, data hold time=0) only one pair of nCS/nWR pulses is formed, but these changed timing options don't correspond to required write diagram. Has anybody faced this issue?Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
are the byte enable signals the same on both accesses? Weird things can happen sometime on those, especially if the CPU is doing a 8 or 16-bit access, or if the memory is not 32 bits wide. Sometimes you get extra write accesses with all the byte enable signals deasserted.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Byteenable is "11" during both write operations, data bus width is 16 bits. It seems that acceptable decision is to change controller data width to 32 bits and use just 16 low bits. At least I haven't noticed any problems with it so far.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Whenever possible, yes it's a lot better to try to stick to 32 bit to avoid weird issues with the automatic width adapters.
![](/skins/images/45C6C2D737ED71F4C51F0145C8CB1E9C/responsive_peak/images/icon_anonymous_message.png)
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page