- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I use Quartus II 9.0 as the development tool and choose the BDF as the design input. At the begin, everything is fine and I have complteted the design and perfromed the simulation by simulator of Quartus II. However, the quartus output one warning message (Error:Cann't open file E:\hardware\CPLD\design.bdf and Cann't find requested location) after one time of synthesis. Then, I closed the project and open the project again. The BDF file can not be opened. The error message is shown as above. Is there any solution?
Thanks!Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Probably not. It sounds like your file or drive is corrupted.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Anyway, thanks for your reply.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page