Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
17255 Discussions

Re-numbering entities

Altera_Forum
Honored Contributor II
‎02-24-2011 05:03 PM
1,523 Views

Hey, 

 

The entities in my Quartus II schematic get numbered in disorganized patterns quickly, e.g., inst, inst18, inst7, inst34... etc. Is there a simple way to re-number them, left to right, e.g. inst -> inst1, inst18 -> inst2, inst7 -> inst3...? 

 

I'm using Quartus II 10.1 sp1. 

 

Thanks for your help, 

 

Owkmann
0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎02-24-2011 06:37 PM
815 Views

use an HDL and give the entites whatever name you like.

0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎02-24-2011 07:30 PM
815 Views

There isn't anyway that I know. I would recommend right-clicking -> Edit Properties on each symbol and giving it an understandable name. In older versions of Quartus(pre 10.0) you could just click on the name and directly edit it.(Large blocks that have obvious names don't need this, but small repeated structures like a dff should.) It's a little bit of work, especially if you haven't done any yet, but well worth the readability once done.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.