Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16557 Discussions

The attached LPM-counter symbol does not work.

OJin0
Beginner
638 Views

I use Quartus (Quartus Prime 19.1) Lite Edition.

The attached LPM-counter symbol does not work.

The green text on the symbol is also weird.

Any problems?

0 Kudos
6 Replies
SyafieqS
Moderator
568 Views

Hi Oksang,

 

I have seen the attached file there where you want to make a 16-bits up counter, what is the things does not work? Is it the simulation or the compilation. Besides, the weird which green symbol there is just a setting displayed whenever you select option in parameter setting.

 

Thanks,

Regards

0 Kudos
OJin0
Beginner
568 Views

Hello, thanks for the reply.

Counter14 does not work.

Today, LMP_COUNTER is newly loaded from IP-Catalog, but it does not work. Schematic and simulation wave photos are attached.

 

Best regards,

Oksang

0 Kudos
OJin0
Beginner
568 Views

When the system clock was designed with LMP-COUNTER (COUNTER_14), the system did not work.

0 Kudos
OJin0
Beginner
568 Views

This is a test bench file.

0 Kudos
SyafieqS
Moderator
568 Views

Hi Oksang,

From the counter14_schematic.jpg, What I can tell is the the input pins clock is not connected. Try to connect the input first and also I not sure if that is the correct way to insert all 16-bits output pins.

 

Thanks,

Regards

0 Kudos
OJin0
Beginner
568 Views

The input pins clock (mclk_in) is connected by the output pin (mclk_out) to which co of PLL03_50 is connected and a hardware jumper on the board.

This is the same as the mclk_in signal in the attached simulation wave picture.

In addition, a schematic and simulated wave picture are attached.

Is there any more material you need to review counter14?

 

Best regards,

Oksang

0 Kudos
Reply