- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Quartus 16.1 TimeQuest takes long time when reading .sdc file and generating reports. Before I have used some smaller Cyclone and MAX 10 device families and running TimeQuest tasks took just few seconds. Now I am working on project with Cyclone V GX device. "Read SDC File" task runs about 1 minute. "Update Timing Netlist" task runs about 3 minutes. Is this normal?Link Copied
4 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Anyone????
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- Anyone???? --- Quote End --- I get similar figures or worse with Q 16.1. It also takes 15 minutes or so to stop after issuing error messages. It is as slow as a camel.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
And there is nothing to do about that? Project compilation takes near 40min and Timequest takes few minutes when reading sdc file and generating reports. It is complete waist of time...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How complex is your design and how complex are your constraints? It could just be your design.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page