Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17268 Discussions

cant read map(P)

Altera_Forum
Honored Contributor II
‎11-01-2012 11:30 AM
1,849 Views

Hello! I installed ModelSim Starter Edition 10d with sp1 and sp2 ( Quartus II 12.0sp2 already installed) . Windosw XP. all programms on disk d: . When I am trying to create ( or open )project it writes ModelSim Error: "can't read "map(P)": no such element in array. " 

 

I try to reinstall all programms. The same result. 

 

When I try to shut down ModelSim it asks ( Are you sure?) and does not react when I press YES. 

 

And after installation it created icons on working table, but did not create launches in  

Start Menu->programms. So I launch them from working table.  

 

I checked all system variables and I did not find variable $MODEL_TECH . Should it be there? And if yes what it be equal ? 

What to do? Huge programm is out of use on my PC. 

 

Thank you.
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.