Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17267 Discussions

sccom not found

Altera_Forum
Honored Contributor II
‎05-02-2010 10:45 PM
1,575 Views

Hello, 

 

I have the Modelsim SE 6.5b installed. It works fine with Verilog, SystemVerilog, VHDL, etc., but it doesn't work with SystemC. The returned message is: 

** 

couldn't execute "/opt/altera9.1/modelsim_ase/linux/sccom": no such file or directory 

** 

But I can find this binary file in the "bin" folder! So, I made a symbolic link in the linux directory, but it did not work again. 

 

Could someone say me what I'm doing wrong? 

 

Thanks.
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.