Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17267 Discussions

simulation issues with quartus 9.0sp2

Altera_Forum
Honored Contributor II
‎01-22-2011 02:00 AM
1,061 Views

when i create a block diagram for example (AND gate) i try to simulate it.which the nodes pins where not there. So, this is what i did i went to file -> vector waveform files then i went to view-> node finder to find the pins. And they are not there and it says no nodes available Run analysis. So my question is what is the problem.

0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.