- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
in TSE datasheet,the timing requirement about the data using by Avalon-ST interface.but the figure 51 and 55(shown below) confuse me.in Avalon-ST transmit interface as shown in figure 55,when should I change the data,in rising edge or falling edge of ff_tx_clk,or both?like figure 55,and in receive operation in figure 51,when should I read the data,as shown in figure,using falling edge of ff_rx_clk,but figure 51 and 55 using the different timing diagram.
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page