- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The Altera DSP development kits (both the Stratix 1S80 and 1S25) contain 2Mbytes of fast SSRAM. Unfortunately, I have not been able to get this SSRAM to operate, with either a Nios 2 processor using SOPC builder, nor with DSP Builder.
Its a little more complicated than simple SRAM because of the use of the clock and a few additional control signals so I am not even sure how to configure User Interface Logic as an Avalon module. I cannot find anything on the Altera web site that talks about how to use this memory, other than a listing if the pin assignments in the user manuals for those two boards. Am I missing a reference design somewhere for either of these 2 boards that shows how to use this memory? The memory is the IDT 71V3578 256Kx18. There are 4 of these on the boards. The data sheet is: http://www1.idt.com/pcms/tempdocs/71v3578_ds_34501.pdf (http://www1.idt.com/pcms/tempdocs/71v3578_ds_34501.pdf) Any suggestions ? dwcLink Copied
0 Replies

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page