Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12745 Discussions

StratixIII dsp board uclinux tse driver

Altera_Forum
Honored Contributor II
‎11-16-2010 11:36 AM
1,133 Views

Dear all, 

I'm having trouble with uclinux on a StratixIII Altera dsp board. The system boots correctly but, when I try to start the network, it does not work. I tried both sls and tripple speed ethernet driver without success. Have you a working Altera project with the network (and in case the corrected driver)? 

Regards 

Marco.
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎12-01-2010 03:27 PM
428 Views

Make sure you also select the correct PHY driver for that board.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.