Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
12748 Discussions

Where does IDE copy the romfs ?

Altera_Forum
Honored Contributor II
‎06-15-2005 11:32 AM
1,238 Views

Hello, 

 

I have generated a linux kernel and a filesystem with the Nios2 IDE. When I upload the kernel, I suppose it is uploaded on my reset address (specified in SOPC builder) since the kernel starts at boot. But how does the IDE find the address where to upload the filesystem in flash ? I need to know that in order to use properly my map file for the MTD driver.  

 

Thanks for help. 

 

Pod
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.