- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am trying to setup a NIOS project and I would like to use the SDRAM on the board. Unfortunately, I seem to be unable to access the chip. When trying to store the software on the chip, I get the classical "Verify failed" error. I tried the memtest template and apparently, it fails right at the start with "Data bus test failed at bit 0x1". As far as I understand, this means that my SDRAM configuration is wrong. Unfortunately, I don't see where. I have a PLL ensuring that the SDRAM clock leads all other clocks and the pins are well configured. I attached my project to this post. Thanks in advance, FofeuLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Try using the system console to test if everything is working. If you are unfamiliar with tcl syntax, this is also a good place to start because you get interactive feedback of what you typed.
I used to get the ''verify failed'' error too. This was because my clock or reset wasn't working properly.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page