- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey,
I have an ArriaV which normally configures using Active Serial mode from a hot-pluggable flash. It's possible to change the flash card during operation, but the FPGA currently retains the configuration of the original flash. Is there some way to control nCONFIG from within the core logic so I can trigger the Active Serial to reload the configuration from the new flash? Thanks, SamLink Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Should be possible through remote update core.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yep, Remote Update core with pretty much everything else disabled does it.
Thanks!
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page