Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Novice
186 Views

Combining Active Serial and JTAG for Configuration

Jump to solution

Chapter 8 of the Configuration Handbook describes combining different configuration schemes. In the section that describes combining AS (Active Serial) mode and JTAG mode, this chapter indicates the JTAG interface is used to configure the FPGA while the AS interface is used to program the serial configuration device.

In this configuration, can the JTAG interface also be used to program the serial configuration device?

Thanks,

Hal 

0 Kudos

Accepted Solutions
Highlighted
Employee
159 Views

Thank you for your clarification. For your question, yes it can be. However, you will need to use different bitstream for that. To program the flash device, you will need to generate JIC programming file. To program FPGA, you will need to generate SOF programming file for that.


View solution in original post

5 Replies
Highlighted
Employee
176 Views

Sorry, before we get started. May i know which device are you referring to?


0 Kudos
Highlighted
Novice
171 Views

Hi YuanLi,

I'm referring to a Arria II GX device (EP2AGX65CU17I3G).

Hal

0 Kudos
Highlighted
Employee
160 Views

Thank you for your clarification. For your question, yes it can be. However, you will need to use different bitstream for that. To program the flash device, you will need to generate JIC programming file. To program FPGA, you will need to generate SOF programming file for that.


View solution in original post

Employee
141 Views

I am glad that it helps. I am closing this thread. If you feel this is helping you, kindly give me a good rating. Thanks


0 Kudos
Highlighted
Novice
136 Views

Thanks for your quick and informative replies!  I appreciate it.

Hal

0 Kudos