Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20641 Discussions

Cyclone 10 GX Configuration Time

HamzahS
New Contributor I
474 Views

Hi,

 

We have a custom made PCB with a Cyclone 10 GX FPGA that uses ASx4 configuration scheme. Everything works fine except the boot (FPGA entering User Mode) time. It's too long to pass our requirements. It takes around:

1- Fast POR: 220 ms

2- Standard POR: 360 ms

 

We would like to get it under 100 ms even if it gets to changing design and configuration scheme.

 

Kindly advise on whether this is possible or not, and how.

 

Thanks,

-Sulaiman

0 Kudos
1 Solution
YuanLi_S_Intel
Employee
461 Views

You may refer to cyclone 10 gx for the estimated configuration time for every configuration scheme.

https://www.intel.com/content/www/us/en/docs/programmable/683828/current/minimum-configuration-time-estimation.html


You might need to consider PS configuration scheme if you are looking for time with less than 100 ms.


View solution in original post

0 Kudos
3 Replies
YuanLi_S_Intel
Employee
462 Views

You may refer to cyclone 10 gx for the estimated configuration time for every configuration scheme.

https://www.intel.com/content/www/us/en/docs/programmable/683828/current/minimum-configuration-time-estimation.html


You might need to consider PS configuration scheme if you are looking for time with less than 100 ms.


0 Kudos
HamzahS
New Contributor I
453 Views

Could this be done without using another FPGA or CPLD?

0 Kudos
YuanLi_S_Intel
Employee
445 Views

For PS configuration, you need a CPLD or a processor for that.


0 Kudos
Reply