- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Does anyone know were I could find Schematic symbols for Altera Cyclone 10 FPGA Family?. Thanks.Link Copied
7 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Pelo,
Check the link. https://www.altera.com/support/support-resources/download/board-layout-test/pcb/pcb-cadence.html Best Regards, Anand Raj Shankar (This message was posted on behalf of Intel Corporation)- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Does anyone know were I could find Schematic symbols for Altera Cyclone 10 FPGA Family about Altium?.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you Anand, but I need symbols for Altium not for ORCAD.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Check for translator or find it from Altium library. http://www.altium.com/documentation/17.1/display/ades/((allegro+import))_ad Best Regards, Anand Raj Shankar (This message was posted on behalf of Intel Corporation)- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You need to import Orcad or Allegro libraries into Altium tool. The tool will convert these Orcad/Allegro libraries into the Altium format.
Download the supplied Orcad/Allegro libraries. Enable the importer from Altium. Import the downloaded Orcad/Allegro formats into Altium.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Any update for Altium symbols for Cyclone 10 devices?
--- Quote Start --- I downloaded the ORCAD library from Altera web: 10cl006.olb But the Altium import failed, "File not reconigzed". --- Quote End ---- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am sure I am just being a total noob but after downloading and installing the library the symbols dont appear to have a footprint associated with them...ideas?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page