Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20704 Discussions

Cyclone V ASx4 configuration

Altera_Forum
Honored Contributor II
‎05-04-2018 02:20 PM
1,233 Views

I've got a Terasic Cyclone V GX development board. I removed the EPCQ256 configuration device and am testing another alternative (Micron MT25QL256ABA). I created a simple project with LEDS and "generic_quad_spi_controlelr2" and am using JTAG indirect programming to program the device (jic file). 

 

Quartus (17.1) will program the device without error. When I created the jic in "Active serial" mode it is able to boot but in "Active Serial x4" it isn't. 

 

Any thoughts?
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎05-16-2018 07:57 AM
436 Views

Hi, 

Although you are using the Quartus Prime software version 17.1, Can you check once by setting the non-volatile configuration register from the following link for ASx4? 

https://www.altera.com/support/support-resources/knowledge-base/component/2018/how-do-i-enable-micron-s-mt25q-support-for-eol-of-epcq---256mb--.html?cq_ck=1522223941654 

 

Let me know if this has helped resolve the issue you are facing or if you need any further assistance. 

 

Best Regards 

Vikas Jathar  

Intel Customer Support – Engineering 

(Under Contract to Intel)
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.