- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello all,
Is there a way to put a Cyclone V GX FPGA into a sleep/hibernation/low-power mode? Our design will involve the system being idle for long periods of time, and we're hoping to keep power draw at an absolute minimum when it is not active. Thank you!Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There's no such mode. However, if you stop the clock you'll save a lot of power.
If you want to save even more power for "long periods of time" turn the power off to the device. Then power it up and let it boot when you need it. Cheers, Alex- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ah, okay, I must have been thinking of a different device that had that mode available.
I think shutting off power will probably be my best bet, I think the config time for the Cyclone V is not very long, a few ms. Thanks Alex.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Perhaps a few hundred ms, but not long either way.
Cheers, Alex
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page