- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apologies if this has been answered elsewhere, I seem to have read about the issue but can't locate my source now.
I've transferred my design to EPCS memory of the DE1-SOC board. Now regardless of the state of the red power button, whenever I plug in the DC adaptor, the board comes up immediately with no way apparently to switch it off except pulling the plug. I liked being able to power up/down the board using the red button while using JTAG mode, can it not be used in AS mode at all? Can I power the board down under software-control?Link Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page