Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers

Dev board stands

Altera_Forum
Honored Contributor II
982 Views

Hi 

There doesn't appear to be a newbie intro section to the forum, hope this is in the right place. 

 

I'm new here, my name is Colin and I've recently purchased two Cyclone III dev boards, for FPGA and DSP. I know virtually nothing about either, so I'm hoping to learn from you. 

 

My first question is a rather basic one, this seemed like the most appropriate part of the forum to post it in; are there any stands on the market that I can mount my two dev boards on? I really don't like having them lie on the bench. I'm looking at perforated aluminium on the 'net but it's just guessing if the perforations will correspond with the four hex mounting spacers that come attached to the dev board. 

 

I'm really hoping to learn something about the two subjects from you all, as long as you realise my initial questions are probably going to seem a little basic to most of you.
0 Kudos
0 Replies
Reply