Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Honored Contributor I
729 Views

EPCS16 and NIOS II (being stupid again!)

Hello all. Bit confused about addresses and offsets. Using alt_write_flash. Setting the offset to 0x100000. After performing the command I read the FPGA contents with Quartus Programmer and look at the contents with a hex editor. The stuff I have written appears at 0x100087. The bottom of the EPCS has Quartus info in it. Do the flash commands take this into account? Or do I have to handle this offset of 0x87? If so, is it always 0x87? 

 

Probably being stupid again but any help much appreciated.
0 Kudos
1 Reply
Highlighted
Honored Contributor I
3 Views

Any ideas?

0 Kudos