- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello all. Bit confused about addresses and offsets. Using alt_write_flash. Setting the offset to 0x100000. After performing the command I read the FPGA contents with Quartus Programmer and look at the contents with a hex editor. The stuff I have written appears at 0x100087. The bottom of the EPCS has Quartus info in it. Do the flash commands take this into account? Or do I have to handle this offset of 0x87? If so, is it always 0x87?
Probably being stupid again but any help much appreciated.Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Any ideas?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page