Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21088 Discussions

EPE Early Power Estimator

Altera_Forum
Honored Contributor II
‎06-15-2018 07:26 PM
2,120 Views

EPE Early Power Estimator Excel file doesn't allow me to change VOD setting from 31 to any other number through Transceiver section of Cyclone 10 GX EPE.  

 

The message I am getting is 

 

" The cell or chart you are trying to change is on a protected sheet. To make a change, unprotect the sheet. You might be requested to enter a password" 

 

Then I went to "Review" section of Excel by clicking Review on the top center of Excel Program. Then I selected "Unprotect Sheet". The excel asked to enter password.  

 

I don;t know the password :)
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎06-19-2018 01:23 AM
1,323 Views

Hi, 

All the features in the EPE spreadsheet to work properly, you must enable some macros so refer the following link to enable macros. 

https://www.altera.com/support/support-resources/operation-and-testing/power/c10-gx-power_estimator_download.html 

 

Let me know if this has helped resolve the issue you are facing or if you need any further assistance. 

 

Best Regards 

Vikas Jathar  

(This message was posted on behalf of Intel Corporation)
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.