Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
All support for Intel NUC 7 - 13 systems has transitioned to ASUS. Read latest update.
20590 Discussions

EPE Early Power Estimator

Honored Contributor II

EPE Early Power Estimator Excel file doesn't allow me to change VOD setting from 31 to any other number through Transceiver section of Cyclone 10 GX EPE.  


The message I am getting is 


" The cell or chart you are trying to change is on a protected sheet. To make a change, unprotect the sheet. You might be requested to enter a password" 


Then I went to "Review" section of Excel by clicking Review on the top center of Excel Program. Then I selected "Unprotect Sheet". The excel asked to enter password.  


I don;t know the password :)
0 Kudos
1 Reply
Honored Contributor II


All the features in the EPE spreadsheet to work properly, you must enable some macros so refer the following link to enable macros. 


Let me know if this has helped resolve the issue you are facing or if you need any further assistance. 


Best Regards 

Vikas Jathar  

(This message was posted on behalf of Intel Corporation)
0 Kudos