Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20704 Discussions

FPGA CRC ERROR due to flipping of SRAM bits

MilindVaidya
Beginner
‎02-01-2021 11:33 PM
509 Views

One of the product has FPGA  Cyclone 3 EP3C120 device.

It is observed on four different customer location around the world that CRC Error pin is asserting high continuously due to flipping of SRAM bits.Though after re-configuring the device with correct data bit values, the device is functioning correctly for all the cases,What are the possible reasons for the flipping of these SRAM bits?

Is there any known issue / Limitations that are causing  this flipping of SRAM bits?

0 Kudos

Link Copied

1 Reply
JohnT_Intel
Employee
‎02-02-2021 09:38 PM
497 Views

Hi,


There will be CRC error occurring when there is Single Event Upset happening that cause the CRM bit to flipped.


You may refer to https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyc3/cyc3_ciii51013.pdf for more information.


0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.