- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When I test the Altera Development Kits DK-DEV-10AX115S-A, I found some defective in J2. I connect the AD9265-FMC-125EBZ into J2, then I can't receiver the good response. Of course, I promise the AD9265-FMC-125EBZ is good. And when I change another DK-DEV-10AX115S-A, the result is good. So, I came to the conclusion that the original DK-DEV-10AX115S-A was bad. I measure the impedance of J2 with a multimeter, and I find D18(FMCB_LA_TX_N6) and G12(FMCB_LA_RX_P2) are about 30kohm to GND, they are difference with another good one. So I want to repair or replace the Development Kit?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Izhou5,
The RMA is being processed. I believe internal team is supporting you now for this. Please let me know if you have any other concern.
Thank You.
Regards,
YL
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
S/N:10APCIe0003421
P/N:6XX-44366R-0G
I bought it from Mouser
Waiting for response.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi lzhou5,
Apologize that we dont provide repair services to development kit. I will continue to support you via private message for RMA request.
Thank you.
Regards,
YL
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Izhou5,
The RMA is being processed. I believe internal team is supporting you now for this. Please let me know if you have any other concern.
Thank You.
Regards,
YL

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page