How do I place the GPIOs in tri-state until configuration is finished? - Intel Community

Programmable Devices

CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers

How do I place the GPIOs in tri-state until configuration is finished?

1,309 Views

I found that GPIOs were driven high for 400MS before enter user mode when I used EP2C70 .I want to know what should I do if I want that GPIOs be driven tri-state or low before the device enter user mode?

3Q!

Link Copied

1 Reply

431 Views

IOs are always tristated during configuration.

What device are you using?

Copy link

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.